Hi, I have just purchased the digi 9636 soundcard and I am now experiencing various problems. I have installed the drivers according to the instructions and the following problems are now occuring,
Cubase VST/ 32 5.0 constantly crashes when trying to boot.
The only way I can get cubase to load is to remove the hammerful ASIO from the ASIO drivers folder.
In the packaging their is a short grey lead with a two pin plug at each end. I am not sure where to put this. What is it for? as it is not explained.

I would appreciate any advice or help you can give concerning this matter, as I can't locate anything about this particular problem in the manuals. I have a Mac G3 blue tower OS 9.0, and i am new to adat and dont really now what the hell im doing any help would be useful thanks

regards Ben

Check versions of Cubase (higher than 5.0 it is now something like 5.01 or 2 may help…

Check versions of RME drivers…

Check your OS version, if you're on 9.0 to 9.02 go 9.04, else upgrade to 9.1 (right from an installer not from a 9.04, it's a mess then) or 9.22

Before that :

start up zapping the PRAM (command + option + P + R on start up, screen stay dark, you must hear 3 times the startup sound before letting go and remove your fingers)

rebuild the desktop (command + option on start up until the mac asks for)

the grey cable may be a bridge to link cards…