|
  |
 Oms Recognition Problems, OMS recognition problems |
|
|
|
|
 Sat 23 Aug 2003, 08:02
|
Newbie
Group: Members
Posts: 1
Joined: 23-Aug 03
From: Wichita - US
Member No.: 23,467
|
Dear Mac-music readers-
I am currently setting up Pro Tools LE version 5.1.1 on a Mac G4 dual 1ghz. I installed the Pro Tools software and was attempting to configure OMS when I ran into a snag. I have my midi devises set up in a chain as follows: Digi 001 out to Yamaha DX7II in, DX7II out to Emu Orbit in, Orbit thru to Kurzweil MicroPiano in, MicroPiano thru to Alesis NanoBass in, Nanobass out/thru to Digi 001 in. When I go through the steps to configure my studio in OMS, it recognizes my Digi 001 and the first devise in my chain, my controller, a Yamaha DX7II, but nothing beyond that. If I use the “customize” feature in OMS and manually enter the other devises, and then try the “test studio” feature in OMS, I get no midi response from the devises. Is the chain that I have stated non-functional or is there some setting on one of the devises that I need to change? I will eventually be using Emagic’s Logic Platinum 5 as my sequencer, but I first need to get my midi devises to communicate. Any input you could provide would be greatly appreciated. Thank you for your time.
Sincerely,
Chet
|
|
|
|
|
|
|
|
 Fri 26 Sep 2003, 03:05
|
Moderator In Chief (MIC)
Group: Editors
Posts: 15,189
Joined: 23-Dec 01
From: Paris - FR
Member No.: 2,758
|
You're chaining way too many MIDI devices on one port only. Try with 3 at most for the others you'll need a second port. The MIDI standard works ok up to 3 devices or less on the same port (even if all channels are not used). After 3 devices roblems arise, timing goes bonkers…  Note that the DX7 as an early MIDI device can be a bit a bit uncooperative. (not transmiting data etc). Hope it'll help 
--------------------
|
|
|
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
|
|
