Usually play my Guitar directly through my G5 Imac using a 1/4" --> 1/8" adapter on the end of my guitar cable... I'm using Amplitube and Guitar Rig software (Garageband too to import the tracks). Found a cheap Pignose Amp with pre-amp out and thought I could use it as a pre-amp to make the sound a bit richer - but the speaker on the Pignose doesn't cut out when used - is this normal? I can remove the speaker wires from the Pignose (internally) if I need to - does anyone know if this will work as a pre-amp??
http://nav.440network.com/out.php?mmsc=forums&url=http://www.pignoseamps.com/index.php?disp=detail&subcat=portamps&id=253
The speaker not turning off is normal...it's just an out, it won't mute the speaker output. It should work as a pre-amp, just not a silent one.
Disconnecting the speaker can damage the amp unless you use a speaker load, like a thc hot plate.
I would be cautious of running a amped guitar signal straight into your G5 mini jack, it might fry the audio board.
I wrecked a stereo amp Hifi system once by playing guitar into it.
If you had some sort of Audio interface or even a mixing desk before going into the g5, it might soften the signal and give you control over volume output going into g5.
Im not sure really, other peoples thoughts??
On the load issue… it's at least one if the amp is valve driven, then there MUST be a load after the amp (which can be a lamp btw, but i'd go for something less DIY myself for daily use). For other non-valve, I don't know, so I won't give advice.
The sound from the loudpeaker/cabinet in a guitaramp is a very important component in the all-over perceived sound.
That's why the Line 6 POD has a switch for "direct out/amp out" at the left/right output.
In amp-mode the POD:s speaker-cabinet simulation is disabled.
It is also important that the signal-levels and impedances from preamp-out into
"recording-gear/power-amp input" - have the proper ratios.
Both for getting a good signal for your recording gear to work with - and to avoid distortion
and unnecessary hiss.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)