MacMusic.org  |  PcMusic.org  |  440Software  |  440Forums.com  |  440Tv  |  Zicos.com  |  AudioLexic.org
Loading... visitors connected
Welcome Guest
> Sound Studio + M-audio = No Input Levels?!, can't adjust input signal levels
dickmanne
post Sun 11 Dec 2005, 23:19
Post #1


Newbie


Group: Members
Posts: 1
Joined: 11-Dec 05
From: Sunland - US
Member No.: 73,767




Hi anyone. Hope there's an answer for this one:

Have digitized aout 100 vinyl LPs with great results using Felttip's Sound Studio.
Unfortunately the 1/8 inch audio input jack on my iMac was damaged and rendered inoperable.
Purchased M-Audio's Firewire Audiophile digital audio interface unit as an alternative to signal input at damaged jack. Modest signal achieved through firewire port but input level adjusters on Sound Studio's software user interface are grayed-out and unable to be used as before to tailor the levels. You can see them gray-out as the M-audio device finishes "booting" several seconds after turning it on.
Further, output adjustments on M-Audio unit to boost signal from receiver/preamp to computer produce no effect even though sliders move, etc.
Have checked all appropriate boxes, dotted all "i"s, crossed "t"s etc. numerous times on every available pull-down window or adjustment pane on the Mac and all software and still can't bring the signal up to appropriate recording levels.

Any advice is appreciated. I love hearing my old vinyl!!!
Go to the top of the page
 
+Quote Post

Posts in this topic


Reply to this topicStart new topic
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:

 

Lo-Fi Version - Fri 13 Dec 2024, 20:08
- © MacMusic 1997-2008