 Bulk Dump Check Sum Error |
 Sun 29 Feb 2004, 12:32
Post
#1
|
|
 Rookie  Group: Members Posts: 40 Joined: 30-Apr 01 From: München - DE Member No.: 492  |
I've got a Roland JV 1080 and recently for the the first time ever I got the message "Check Sum Error" when trying to reload a bulk dump I'd saved in my sequencer (Logic). The synth didn't respond to anything - it just kept flashing the message "Check SUm Error" so I eventually switched it off. Then when I switched it on again, the sounds were very strange i.e. there was suddenly lots of reverb and/or delay and/or chorus on patches in my performance where previously there had been none. I didn'T know what to do so I set the synth back to Factory Settings. In the manual it just says you have "correct the check sum".
I scrubbed the bulk dump from the sequencer and recorded a new one. When I played it back to the synth I got the same error message. My question is: how do I rectify this problem? -------------------- Waiting on my new MacBook Pro
|
 |
 
|
Posts in this topic
karambos Bulk Dump Check Sum Error Sun 29 Feb 2004, 12:32
dixiechicken I'm not a midi-guru by any means, but…
Most s... Sun 29 Feb 2004, 16:58
azusa Before going any further, you should reset JV1080 ... Sun 29 Feb 2004, 23:57  |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
