Toslink Noise With 828 |
Wed 11 Jul 2007, 18:02
Post
#1
|
|
Newbie Group: Members Posts: 3 Joined: 23-Jul 04 From: Austin - US Member No.: 47,512 |
This is likely not a problem specific to the 828, but since that is what I am using, I hope to get it addressed here. I use a 2 meter toslink to connect an Alesis LX20 ADAT output to the input of my 828. Recently, I started hearing static like noises that I tracked down to that connection. At first, the extra length of the cable was coiled and uncoiling it made a significant difference in the amount of noise. However, there are still occasional (every second or two) clicks of noise. Can anyone explain the likely cause of this?
Thanks. |
|
|
Replies
(1 - 1)
Thu 12 Jul 2007, 09:05
Post
#2
|
|
Newbie Group: Members Posts: 3 Joined: 09-Jul 06 From: Leicester - UK Member No.: 81,309 |
Hi Macdrummer
the Tos link is fibre optic if your coils are too tight the light can't skid round the corners well enough and signal gets absorbed, this can cause corruption of the data and hence noise. Other sources of noise can be dirty/dusty terminations and fractures in the lightpipe itself.If you borrow a replacement it may be worthwhile swapping out the cable and checking for an improvement. If you are coiling up cables consider a shorter cable, I'm not being funny, that will also give you a stronger signal since all cables have attenuation and this is multiplied by length. regards steve |
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members: